5 Mistakes You Make When Coloring Your Beard
If you are a man who has begun spotting grey hairs appearing on your beard, then this article is exclusively meant for you. Did you ever attempt dying it? It may so happen that you have only felt disappointed with the results. You must be seeking a few coloring tips for your beard.
That is why, to address the issue, in this writeup we have figured out the top five beard coloring mistakes, instead of a simple “how to dye your beard post” blog.
It is always advisable to consult a professional barber on some of these blunders. Everyone needs a dose of professional advice as part of the mix. So, the five commonest mistakes you may be committing while dying your beard are as follows-
Choosing the Wrong Color
It has been observed that a lot of men opt for jet-black coloring for their beards while their real color is more of a deep brown. The general rule of thumb should be that if the hair on your head is jet-black, that should be the color of the dye color you select for your beard. There is a wide range of various shades to pick up from. Consult with the nearest barbershop in Rancho Cucamonga or other places for ideas.
Not Applying Petroleum Jelly
Probably you weren’t expecting this mistake to be highlighted. But you need to be cautious. Applying petroleum jelly around the upper neck, the cheeks, and sideburns facilitates you to prevent a drippage of any kind. Also, if coloring does seep inside an unwanted place, the jelly compensates for convenient cleanup. What you may try is simply grab a little Vaseline and dab it around the areas you don’t wish to be colored. The jelly offers a protective barrier for leakage. By the end, you will notice a much more practical look.
Not Allowing the Dye to Set
One thing that you need to register in your head is that if you leave the dye in your beard for at least seven minutes, then it is key to a practical appearance. Don’t make the mistake of just applying the coloring, and a few minutes later, washing it out. In the end, you will observe that the whiskers are not getting the rich color you were looking for.
Facial hair becomes coarser as we continue to age. So, it implies that the absorption of the product is going to consume a long time. At a minimum, allow it to settle for five minutes. When you are in a hurry, contemplate applying a hairdryer. Set too low on your beard. Hold the dryer arm’s length from your beard and softly wand back and forth to speed up the drying process.
Not Rinsing Out Additional Coloring
Another common mistake men make with beard coloring is not rinsing out the extra coloring once it dries. You must apply a dime-size amount of shampoo. Simply place a meager amount of shampoo in your palm while you get in the shower. Allow the water to initially flow from the showerhead onto your face. Then, apply the shampoo with a downward motion along with your fingers to eliminate the excess. Refrain from rinsing in the sink. It doesn’t do the task properly.
Ignoring the Eyebrows
You may have observed greys creeping into your eyebrows. You may feel tired of tweezering them out. That’s the reason why you should start applying beard coloring to your eyebrows. Moreover, by coloring your eyebrows, it matches your beard. It will make everything seem more natural. Apply a Q-Tip for this grooming hack and immerse it into the coloring. Gradually trace from shaft to the end of the brow. Only a bit will go a long way.
Inference
As you age, your whiskers are bound to become grey and it is inevitable. All of us face it. If you wish to avail yourself of a more youthful appearance, dying your beard can be an amazing option. Also, you may seek additional suggestions from a barbershop in Claremont and elsewhere.
Comments
Post a Comment